These instructions are for the replacement of the Power Ox 220A narrow frame configuration drive belt.
Support the unit with jack stands or another secure method, so that the power units left side wheel is off of the ground.
With the unit securely supported, remove the belt and pulley cover by removing the five 5/16” bolts and washers (A).
Remove the lower frame tube (B) by removing the eight 3/8” carriage bolts and lock nuts that secure it to the frame and fenders.
Remove the two 3/8” carriage bolts and locknuts (C) that secure the left fender assembly to the upper frame tube. Removing the bolts allows the fender assembly to rotate freely on the axle.
The belt can now be removed from the pulleys and routed over the fender assembly.
Route the new belt under the tire and over the fender assembly.
Install the new belt over the pulleys as shown.
Install the two 3/8” carriage bolts and locknuts through the upper frame tube and fender.
Torque the bolts to 31ft-lbs (42 Nm).
Install the lower front frame tube. Install all eight 3/8” carriage bolts and lock nuts hand tight.
Torque the bolts to 31 ft-lbs (42 Nm) alternating between all of the bolts until the torque is reached.
Install the belt and pulley cover using the five 5/16” bolts and washers (E). Torque the bolts to 210 in-lbs (24Nm).