Remplacement du Roulement de la Bride de l'Essieu Moteur de l'Enrouleur de Plastique

These instructions are for the replacement of the Tilmor Plastic Winder Drive Axle Flange Bearings.

Tools
Douille 5/8"
Clé à cliquet
Clé 7/16"
Clé hexagonale 3/16"
Punch
Marteau
Dead blow Hammer
Clé 3/4"
Douille 3/4"
Clé Dynamométrique
Douille 7/16"
Estimated Time

1 hrs 30 mins

Before You Begin
1
Remove the Drive Wheel
2
Remove the Drive Wheel
3
Adjusting the Belt Tension
4
Remove the Pulley Cover
5
Remove the Belt
6
Remove the Drive Pulley
7
Remove the Drive Pulley
8
Remove the Bearing Collars
9
Remove the Bearing Collars
10
Remove the Drive Axle
11
Remove the Flange Bearing
12
Position the Flange Bearing
13
Apply Anti-Seize
14
Install the Drive Axle
15
Torque the Flange Bearing Mounting Hardware
16
Install the Bearing Collars
17
Set the Axle Position
18
Remove Set Screws
19
Install the Bearing Collars
20
Install the Set Screws.
21
Install the Drive Pulley
22
Position the Drive Pulley
23
Install the Drive Pulley
24
Install the Belt
25
Adjust the Belt Tension
26
Install the Pulley Cover
27
Install the Drive Wheel